Engine stalling/Santa Fe(SM)

model: Santa Fe	year model: 2004	mileage: 110200 mk
Displacement: 2700cc	Fuel: Gasoline	T/A

Subject: Engine Stalling – junction block

1) Condition:

1. Intermittent Engine stalling during driving.

2) Cause:

1. Poor contact of the Engine junction block

3) Diagnosis:

1. Inspect each sensor and inputted actuator power in IG(ignition key) “ON” condition.
   = Inspect the supplied power to injector: The power is not supplied to injector.
   = Inspect the supplied to idle speed control actuator.
   = The power is not supplied.
2. Inspect engine control relay.
   = Inspect resistance and contact point after removing the control relay: Normal.
   = Inspect the supplied power to control relay ( # 1 terminal and # 3 terminal): 12 volt ( Normal)
   = No signal when checking the #2 terminal.
3. The detached #8 terminal from connector is found when inspect the ER/E connector.

4) Repair Guide:

1. Repair the junction blonck wire pin.