Saturday, October 30, 2010

How to Repair Engine Cut Off After 5 min at Idling

How to Repair Engine Cut Off After 5 min at Idling

How to Repair Engine Cut Off 5 min at Idling

Model: Hyundai Sonata (EF)

Year Model: 2002

Fuel: Gasoline

Displacement: 2000cc

Condition and Study Guide:

  1. Study Engine Cut off After 5 min at Engine Idling
  2. Study Engine sometime hard to Start.

Cause and Study Guide:

  1. Due to CKP wire damage.
  2. Timing plate deformation.

Diagnosis and Study Guide

  1. Study Guide Scan tool check
    = Trouble code = P0340 Camshaft Position Sensor Circuit Malfunction
  2. Study Guide Arase the trouble code with GDS = Ok but after a min the trouble code will return.
  3. Study Guide Check with good CMP but the same
  4. Study Guide Check the timing = OK
  5. Study Guide Since a have a trouble the same before, I decided to open the front of engine .
  6. Study Guide To check the CKP.
    = the trouble found that the CKP wire cut and somebody reconnect
    = Then the timing plate also has a deformation.

Study Guide and Replace Parts

  1. Replace CKP(Crankshaft Position Sensor)
  2. Replace timing plate
 

P0340 Camshaft Position Sensor Circuit Malfunction

 

Study Guide Component Location

clip_image004

Study Guide Description

1. General Description

Study Guide The Camshaft Position Sensor (CMPS) is a sensor that detects the compression TDC of the NO. 1 cylinder. The CMPS consists of a hall type sensor and a target on the end of the intake camshaft. When the target triggers the sensor, the sensor voltage is 5V. If not, the sensor voltage is 0V.Study Guide These CMPS signal is sent to the ECM and the ECM uses the CMPS signal for synchronizing the firing of sequential fuel injectors.

2. DTC Description

If there is no change of signal, the ECM judged as a fault and DTC is set.

DTC Detecting Condition

Item

Detecting Condition

Possible Cause

DTC Strategy

● change in output voltage(ΔVcam) is monitored

● Poor connection
● Open or short in CMPS
● Defective CMPS
● Defective ECM

Enable Conditions

● Cranking switch "ON"

 

Threshold value

● ΔVcam = 0

 

Diagnostic Time

● Continuous

 

MIL ON condition

● 2 driving cycles

 

Auto Repair and Study Guide and Auto Reapir and Study Guide

More info to on how to check CKP HERE

0 comments:

Post a Comment

Locations of visitors to this page